How to Use Be2works Crack 408l to Reset Battery Firmware
Be2works Crack 408l is a software tool that allows you to reset the firmware of laptop batteries that have been locked or damaged by water, overcharging, or other causes. By resetting the firmware, you can restore the battery's full capacity, performance, and lifespan. In this article, we will show you how to use Be2works Crack 408l to reset battery firmware in a few simple steps.
What is Be2works Crack 408l?
Be2works Crack 408l is a cracked version of Be2works, a software program that can read and write the data stored in the battery management system (BMS) chip of laptop batteries. The BMS chip contains information about the battery's design, full charge capacity, voltage, manufacturer, charging voltage, temperature, and chemistry[^1^]. By using Be2works Crack 408l, you can unlock any password for the BMS chip and modify its data to reset the battery firmware[^2^].
Why do you need to reset battery firmware?
Resetting battery firmware can help you fix some common problems with laptop batteries, such as:
The battery does not charge or hold charge properly.
The battery shows incorrect or fluctuating capacity or percentage.
The battery causes errors or warnings on the laptop.
The battery has been locked by the manufacturer or damaged by water or other factors.
By resetting the battery firmware, you can clear these errors and restore the battery's original capacity and performance. This can extend the battery's lifespan and save you money on buying a new battery.
How to use Be2works Crack 408l to reset battery firmware?
To use Be2works Crack 408l to reset battery firmware, you will need the following items:
A laptop with Windows operating system.
A USB-to-SMBus adapter that can connect to the BMS chip of the laptop battery. You can buy one online or make one yourself using a Bus Pirate device[^2^].
A screwdriver and a multimeter to open the battery case and locate the BMS chip.
A copy of Be2works Crack 408l software that you can download from this link.
Once you have these items ready, follow these steps to reset your battery firmware:
Turn off your laptop and remove the battery from it.
Open the battery case carefully using a screwdriver. You may need to remove some screws or clips to access the inside of the battery.
Locate the BMS chip on the battery circuit board. It is usually a small black square with eight pins on each side. You can use a multimeter to identify the pins that correspond to SMBus (SCL and SDA), power (VCC and GND), and thermistor (TH).
Connect your USB-to-SMBus adapter to your laptop and install its driver if needed.
Connect the wires from your USB-to-SMBus adapter to the corresponding pins on the BMS chip. Make sure you connect them correctly and securely.
Run Be2works Crack 408l software on your laptop. It should detect your USB-to-SMBus adapter and your battery automatically.
Select your battery model from the list of supported batteries in Be2works Crack 408l. If your battery model is not listed, you can try using a similar model or create a custom profile using the data from your original battery label.
Click on \"Read\" button to read the data 29c81ba772